Setting Up Your Ruggedreader - In-situ RuggedReader Getting Started Manual

Setting up your RuggedReader

1. Attach the PowerBoot
The PowerBoot Module
RuggedReader is shipped unattached. To
attach the PowerBoot, turn the latches
counter-clockwise until they are parallel to
the stylus holder, with the arrows pointing
towards the communication ports located
at the bottom of the PowerBoot.
2. Attach the hand strap
To connect the hand strap to your
RuggedReader, hold the hand strap
clip at a 45 degree angle and push the
clip onto the RuggedReader bracket.
Repeat the process with the other end
of the hand strap.
3. Charge your RuggedReader
Connect the AC adapter to the
external power port on your
RuggedReader. Charge for at least
12 hours before using. For best
results, turn the RuggedReader off
while charging.
for your
TM
Firmly slide the
PowerBoot onto
the main unit as shown. Pressure should
be applied downward and forward as the
PowerBoot is positioned.
Use the stylus to lock the PowerBoot
latches, by turning them clockwise one half
turn until they are pointed away from the
communication ports.
3