Table of Contents
Advertisement
Caring for your RuggedReader
Changing the PowerBoot Module
You can purchase additional PowerBoot Modules. Before removing
the PowerBoot, back up your RuggedReader to built-in storage.
Built-in storage is not affected by a hard reset. In the rare event that
you experience a hard reset while changing the PowerBoot, you will
easily be able to restore the state of your RuggedReader from this fresh
backup. See RuggedReader Memory and Backup and Restore.
With the RuggedReader turned off, you will have at least 30 seconds to
change the PowerBoot without danger of a hard reset.
1. Before changing the PowerBoot, back up your RuggedReader to
built-in storage using the preinstalled backup program.
2. Turn off the RuggedReader.
3. Remove the hand strap .
4. To unlock the PowerBoot latches,
turn them counter-clockwise until
the arrows point towards the I/O
ports. Ensure the latches on your
new PowerBoot are also in the
unlocked position.
5. Remove the PowerBoot using both
thumbs to push on the PowerBoot
as the arrows indicate.
6. Quickly (within 30 seconds) slide the new PowerBoot onto the
RuggedReader. Lock the latches and replace the hand strap.
Cleaning the RuggedReader
Clean with a soft cloth dampened with water or a diluted mild
detergent. Do not put the RuggedReader in the dishwasher.
Water
The RuggedReader is designed to withstand accidental immersion.
To maintain the water resistant seal, it is important to ensure that the
screws on the CF-Cap are tightened after replacing CompactFlash
cards. Removal of the back case torx screws, or failure to tighten the
CF-Cap screws could cause leakage, and will void your warranty.
20
Push Here
Advertisement
Table of Contents
