System Connections; Remote Control - RCA RCS13101E User Manual

Safety Instructions
The laser mechanism corresponds to the cartridge and stylus of a
record player. Although this product incorporates a laser pick-up
lens, it is completely safe when operated according to directions.
warped, or cracked discs.
compartment. To keep dust from collecting on the pick-up lens, do
not leave the compartment door open for an extended period of
time. If the lens becomes dirty, clean it with a soft brush, or use an
air blower brush designed for camera lenses.
the volume on the unit before you put on headphones. Increase
the volume to the desired level only after headphone are in place.
against extended high-volume play.
discontinue use.
use in potentially hazardous situations. Even if your headset is an
open-air designed to let you to hear outside sounds, do not turn up
the volume so high that you are unable to hear what is around you.
cause hearing loss.
1. Read these instructions.
6. Clean only with a dry cloth.
the manufacturer's instructions.
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
type plug. A polarized plug has two blades with one wider than
the other. A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong are provided
for your safety. If the provided plug does not fit into your outlet,
consult an electrician for replacement of the obsolete outlet.
particularly at plugs, convenience receptacles, and the point
where they exit from the apparatus.
by the manufacturer, or sold with the apparatus. When a cart is
used, use caution when moving the cart/apparatus combination
storms or when unused for long periods of
time.
personnel. Servicing is required when
the apparatus has been damaged in
any way, such as the AC power cord or
plug is damaged, liquid has spilled or
the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.

System connections

terminals.
Note:
Connecting speakers other than
the speakers supplied with the
unit may damage the unit.
Red marked cord (+)
indicated on the identification sticker located on the back of your
AC power plug from the wall outlet.
to standby mode does not disconnect it from the power supply.
To completely isolate the equipment, remove the plug from the
power outlet as some components remain connected to the
electrical supply.

Remote Control

unit.
When the battery becomes weak, the operating distance of the
remote control will be greatly reduced and you will need to replace
the battery.
Note:
If the remote control is not going to be used for a long time, remove
the battery.
WARNING:
sunshine, fire or the like.
CAUTION:
with the same or equivalent type.
Right Left
2. Insert 2 AAA size batteries.
EN
3