Using The Imager; Tool/Work Area Set-Up - RIDGID SeeSnake Micro Operating Instructions Manual

SeeSnake
Tools For The Professional
TM
Tool and Work Area Set-Up
To prevent serious injury, proper set-up of the tool and work
area is required. The following procedures should be followed:
1. Review General Safety Information section of this manual (Page 2).
2. Check work area for:
• Adequate lighting
• Flammable liquids, vapors or dust that may ignite.
Operating Instructions
Do not use excessive force to insert or bend the cable.
Do not use the cable or imager head to modify surroundings, clear pathways or
clogged areas, or as anything other than an inspection device.
The hand-held display unit is not water resistant.
The imager head and its covering are water resistant, but are not acid-proof
plastic covering over time. Avoid submersing the imager head into corrosive,
oily places.

Using The Imager

To turn the unit on, hold the viewer with the LCD screen facing you (Figure 7).
acts as a dimmer for the twin LEDs (Figure 8) that surround the camera on the
imager head and provide lighting.
4
Micro
® ™
Ridge Tool Company
Typical Applications
The SeeSnake Micro is designed as a remote inspection device. Typical
(Figure 10)
(Figure 9), automotive inspection