Table of Contents
Advertisement
Output Learn Mode
To assign a MIDI message to an output, select the output or pair of outputs using the SELECT switch.
Clicking the SELECT switch will cycle through the available outputs and flash the LEDs to show which
outputs will be assigned. After an output is selected, send the appropriate MIDI message to assign the
output. The SELECT mode will time out after a few seconds if a MIDI message is not received. The types
of messages and the respective behaviour on each output depends on the output type.
After selecting an output mode, setting the SETUP switch will hold the output in learn mode and also
send voltages and pulses out of the selected outputs for testing. This can be used to aid in oscillator
tuning, setting up envelope generator and drum voice trigger sensitivity settings, and so on.
Any MIDI channel (except channel 16) can be used to assign an output. After being assigned, the output
will respond to this channel and type of message only, making it possible to control each output on a
different channel if desired.
Learn Mode Details
MIDI Channel 16 – You cannot assign outputs using MIDI channel 16. This channel is reserved for
•
direct control mode and adjusting the clock divider setting.
Note Assignment – CV outputs only support playing notes from note numbers 12-115. Notes
•
received outside this range will be ignored.
Continuous Controllers – You cannot assign outputs using controller numbers 122-127. These
•
are reserved by the MIDI spec and cannot be used.
High-resolution Controllers – Only 7 bit controllers are supported. High-resolution (MSB / LSB)
•
CC pairs are not supported in learning mode. For precision control of the CV DACs, the direct
control mode on channel 16 can be used.
User Manual
// K1600 // MIDI Converter
Hardware Version C/D
Firmware Version 1.2x
August 10, 2012
© 2010 Kilpatrick Audio
6p
Advertisement
Table of Contents
