Table of Contents
Advertisement
Internal Connector Pinouts
To assist in making correct connections, and to aid in the creation of compatible adaptor circuits, the
internal pin headers are documented here. Please note that X15 is a factory setup connector only and
should not be used. Both X11 and X12 connectors are 0.100" pitch pin headers. Standard IDC ribbon
cables can be connected.
Support and Additional Information
Please contact Kilpatrick Audio with additional questions about the K1600 MIDI Converter. We will do
our best to help you make the most of your MIDI converter and welcome your suggestions as to
software improvements or ideas for features on new products. Contact: info@kilpatrickaudio.com
User Manual
// K1600 // MIDI Converter
X11 – MIDI/Test Connector:
1. GND
2. GND
3. GND
4. GND
5. TEST (output for ext. module)
6. MIDI TX (output to ext. module)
7. N/C
8. MIDI RX (input from ext. module)
9. N/C
10. N/C
17p
X12 – Power:
1. -12V input
2. -12V input
3. GND
4. GND
5. GND
6. GND
7. GND
8. GND
9. +12V input
10. +12V input
11. N/C
12. N/C
13. N/C
14. N/C
15. N/C
16. N/C
Hardware Version C/D
Firmware Version 1.2x
August 10, 2012
© 2010 Kilpatrick Audio
Advertisement
Table of Contents
