Midi Implementation; Program Change Commands - Kilpatrick Audio K1600 User Manual

MIDI Implementation

Note On Messages
Note On messages are supported in CV/gate modes as well as trigger output modes. For triggers the
output only stays on for 10ms regardless of whether a note is held down on the keyboard.
Note Off Messages
Note Off messages are only used in CV/gate mode to control the gate outputs. For triggers this type of
message is ignored.
Pitch Bend Messages
Pitch bend messages are used both for note bending when using the CV outputs in note mode, as well as
for output control when pitch bend messages are assigned directly to outputs.
In note mote, the pitch bend affects the overall note pitch depending on the setting of the pitch bend
amount. (default = 2 semitones) The amount for each of the CV outputs can be set independently from 1
to 12 semitones.
When the pitch bender is assigned to a CV/gate output pair or a trigger output, the value of the bender
determines the voltage of the output (CV output) or whether an output is on or off. (gate and trigger
outputs)

Program Change Commands

Program change commands are used to configure specific aspects of the system. They are received on
any channel regardless of the output assignments. This makes it possible to control system-wide
configuration from any MIDI channel.
Program Change Value
Program change: 1-48 (channel 16)
Program change: 1-12
Program change: 13-24
Continuous Controller (CC) Messages
Continuous controllers can be assigned to CV/gate outputs or trigger outputs. Any continuous controller
number from 0-121 can be assigned to an output.
User Manual
Action
Output clock divider: 1-48 = division of 1-48 (default = 1)
CV1 pitch bend amount: 1-12 = 1-12 semitones (default = 2)
CV2 pitch bend amount: 13-24 = 1-12 semitones (default = 2)
// K1600 // MIDI Converter
Hardware Version C/D
Firmware Version 1.2x
August 10, 2012
© 2010 Kilpatrick Audio
13p