Kilpatrick Audio K1600 User Manual page 11

Continuous Controller Mode
In continuous controller (CC) mode, a CC message is used to control an output. The output sends 0V if
the value is less than 64, or +5V if the value is greater than or equal to 64. The output will remain on as
long as the CC value is greater than or equal to 64.
To assign a CC output to a trigger output, click the SELECT switch until the desired trigger output LED is
flashing. Then send a CC on the desired channel and it will be assigned.
Pitch Bend Mode
In pitch bend mode the pitch bend channel message is assigned to a trigger output. Similar to the
CV/gate outputs, the polarity of the pitch bend for a trigger output can be set as well.
To assign a pitch bend to a trigger output, click the SELECT switch until the desired trigger output LED is
flashing. Then send either an upward or downward bend to assign the output and set the polarity. In the
centre position the trigger output will be off regardless of the polarity setting. If upward polarity was
assigned, the trigger output will go on as the bender is raised. If downward polarity was assigned, the
trigger output will go on as the bender is lowered.
User Manual
// K1600 // MIDI Converter
Hardware Version C/D
Firmware Version 1.2x
August 10, 2012
© 2010 Kilpatrick Audio
11p