Table of Contents
Advertisement
Physical Installation
You should install the unit in your modular system using all four screw holes. The unit is designed to
be mounted properly to avoid damage to the internal parts when plugging or unplugging cables, or
adjusting the controls.
Connection Warnings
The CV outputs are buffered, low impedance (100 ohm) outputs designed to drive oscillator 1V/octave
inputs with minimal error. You should not attempt to sum the CV outputs with passive multiples. Doing
so will not harm the unit, but will likely not result in the behaviour you expect.
The gate, trigger and clock outputs are 1000 ohm outputs and should not have voltages fed into them
from other units. They are designed to tolerate the input of between -12V and +12V but are meant for
output only. You should be able to sum the signals using passive multiples, but buffered mixers are a
better choice for achieving proper mixing of signals.
User Manual
// K1600 // MIDI Converter
Hardware Version C/D
Firmware Version 1.2x
August 10, 2012
© 2010 Kilpatrick Audio
4p
Advertisement
Table of Contents
