New Buck Corporation COMBO COAL & WOOD STOVE Owner's Manual page 9

THIMBLE
Prefabricated "Listed
(See Page 19 and 21). Installation instructions from the manufacturer must be strictly followed to
ensure the safety of the system. Clearances to combustible materials must be maintained. Confirm
local building codes for restrictions when connecting stove to masonry thimble through a
combustible wall.
CONNECTION
When a metal prefabricated chimney is used, follow the pipe manufacturer's installation instruction
exactly. Do not mix different pipe. Purchase (from the same manufacturer) and install:
1. ceiling support package
2. wall pass through
3. "T" section package
4. firestops (when needed)
5. insulation shield
6. roof flashing
7. chimney cap
Two methods of chimney installation:
1. Rear exit through wall, exterior chimney outside residence. (See figure 4, Page 8).
2. Rear exit to vertical ceiling exit. (See figure 5, Page 8).
Components illustrated may not look like system you choose, but this demonstrates basic
components needed for a proper and safe installation.
See figure 3 (Page 6) for chimney height. Refer to page 5, "Masonry Chimney" for dimensions.
NOTE: Follow
specified clearance requirements.
DO NOT CONNECT THIS UNIT TO A CHIMNEY
FLUE SERVING ANOTHER APPLIANCE.
2100° UL 103 HT Type Chimney"
TO A METAL
These parts must be listed to
the manufacturer's installation instructions and maintain
metal thimbles can be purchased for use
PREFABRICATED
2100 degree UL 103 HT.
Page 7
CHIMNEY