New Buck Corporation COMBO COAL & WOOD STOVE Owner's Manual page 32

ASSEMBLY BLOWER MOTOR (OPTIONAL)
Blower assembly must be disconnected from the source of electrical supply before attempting the installation,
blower assembly is attended for use only with Combo Coal Stove.
A. To attach optional blower motor to the rear of the unit ,place motor in blower opening at bottom rear shield,
using the two self tapping screw's provided, screw, and secure to rear shield. (See Figure 23)
B. Remove thermostat cover. Take thermostat with wires and slide wires down between Cabinet Back
and Rear Shield out thru blower opening. Screw thermostat to rear shield with provided screws, and
replace thermostat cover. (See Figure 23)
C. Take the wires coming out of the blower opening and put them thru the upper hole in the motor
cage. Attach the two ground wires underneath right motor screw. Connect the white wire from
power cord to the white wire on the motor. Connect black wire from the power cord to a thermostat
wire. Connect black motor wire to the other thermostat wire. Do not route power cord over or under
the unit. (See Figure 23)
D. Center Motor Cage over motor and use the supplied self tapping screws to screw and secure motor
to rear shield. (See Figure 23) Do not route power cord over or under the unit.
BLOWER ASSEMBLY # MACCOAL714
TWO THERMOSTAT
WIRES
REAR SHIELD
REAR FIRE BOX
MOTOR
DO NOT ROUTE POWER CORD OVER OR UNDER THE UNIT.
Figure 23
THERMOSTAT
THERMOSTAT
SELF TAPPING
SCREWS
TWO GROUND WIRE'S,
SECURE BEHIND
THIS SCREW.
PUT MOTOR IN BEHIND REAR SHIELD
AND CENTER, USE THE TWO PROVIDED
SELF TAPPING SKEW'S TO SCREW AND
SECURE MOTOR TO REAR SHIELD
COVER
THERMOSTAT
WITH WIRES
TWO THERMOSTAT
WIRES GO THRU HERE
NOTE: AFTER MOUNTING MOTOR AND CONNECTING
WIRING, CENTER MOTOR CAGE OVER MOTOR AND USE
THE TWO SUPPLIED SELF TAPPING SCREWS TO SCREW
AND SECURE MOTOR CAGE TO REAR FIRE BOX.
Page 30
GROUND WIRE'S,
WHITE WIRE'S GO
TOGETHER
SELF TAPPING SCREWS
SELF TAPPING SCREWS
POWER CORD WITH ROUND.