JVC HR-S6960E Instructions Manual page 28

28
EN
D
Set the tape speed.
Press SP/LP/EP ( ).
p
It is not possible to select EP mode if "COLOUR SYSTEM" is
. (
set to "MESECAM" pg. 51
E
Set the VPS/PDC mode.
Press VPS/PDC (number key "7") to select "ON" or
"OFF".
If "VPS/PDC ON" is displayed on the TV screen, VPS/PDC is
set to ON.
If "VPS/PDC OFF" is displayed on the TV screen, VPS/PDC is
set to OFF.
"VPS/PDC Recording" on page 30.
F
Access the Title Edit screen.
Press the number key "1".
The Title Edit screen appears.
You can access the Title Edit
screen only when "PROG.
NAVIGATION" is set to "ON".
( pg. 48)
G
Enter the programme title.
Press the number keys and
to enter characters, then
press OK. For details, refer to
"Entering Character" on
page 38.
)
e
TIMER RECORDING (cont.)
H
Return to the normal screen.
Press PROG or OK. "PROGRAM COMPLETED" appears
on the TV screen for about 5 seconds, then the normal
screen appears. If "PROGRAM OVERLAPPED" appears
on the TV screen and "Err" on the front display panel, see
page 33.
Repeat steps 1 – 8 for each additional programme.
I
Engage the recorder's timer mode.
Press (TIMER). The recorder turns off automatically and
#
" " appears on the front display panel.
#
To disengage the timer mode, press
NOTES:
To Change The Stop Time . . .
. . . press STOP +/– after pressing OK in step 3. You can
compensate for anticipated programme schedule delays.
To Timer-Record Weekly Or Daily Serials . . .
. . . after pressing OK in step 3, press WEEKLY (number key
"9") for weekly serials or DAILY (number key "8") for daily
serials (Monday — Friday). Either "WEEKLY" or "DAILY"
appears on the TV screen. Pressing the button again makes the
corresponding indication disappear.
To change the channel position number, press PR +/-.
You can programme this recorder to timer-record as many as 8
programmes. If you try to programme the recorder to record a
ninth, "PROGRAM FULL" appears on the TV screen and
"FULL" appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes ( pg. 32).
It is not possible to timer-record a satellite broadcast received
on the channel position "0" by the satellite receiver.
Satellite Receiver Users
To timer-record a satellite broadcast using the S
system:
A Perform "Satellite Receiver Control Setting" on page 16.
B Perform steps 1 – 9. In step 5, you cannot set "VPS/PDC"
to "ON".
C Leave the satellite receiver's power on.
(TIMER) again.
#
V
HOW IEW