Mitsubishi Electric Mr.SLIM PKA-RP35GAL Service Manual page 35

OPERATION PROCEDURE
9. REMOVING THE FAN MOTOR.
(1) Remove the terminal block cover.
(2) Disconnect the connector <yellow> of the wireless remote
controller board.
(3) Remove the front panel.(see the photo 1)
(4) Remove the electrical parts box.(see the photo 8)
(5) Remove the nozzle assemble.(see the photo 7)
(6) Remove the fan motor leg fixing 3screws.
(7) Unscrew the set screws using by alankey and remove it by
sliding the fan motor to right.
(8) Remove the 4screws and remove the motor cover from the
fan motor leg.
10. REMOVING THE LINE FLOW FAN
(1) Remove the terminal block cover.
(2) Remove the front panel.(see the photo 1)
(3) Remove the electrical parts box.(see the photo 8)
(4) Remove the nozzle assembly.(see the photo 7)
(5) Remove the fan motor.(see the photo 9)
(6) Remove the pipe fixture with 2screws.(see the photo12)
(7) Remove the left / right screws of the heat exchanger and
pull the left-hand side up.
(8) Remove the 2screws by sliding it toward you remove the
fixture(fixing bearing).
w The fan motor is removable first , when the fan
removing is hard.
w When resetting the fan to the fan motor.
Locate and fix the shaft after installing the fan.
11. REMOVING THE HEAT EXCHANGER
(1) Remove the terminal block cover.
(2) Disconnect the connector <yellow> of the wireless remote
controller board.
(3) Remove the front panel.(see the photo 1)
(4) Remove the electrical parts box.(see the photo 8)
(5) Remove the corner box.
(6) Remove the nozzle assemble.(see the photo 7)
(7) Remove the 2screws and the pipe fixture.
(8) Remove the 2screws and heat exchanger.
12. REMOVING ELECTRICAL HEATER (PKH-P35/50GALH only)
(1) Remove the terminal block cover.
(2) Disconnect the connector <yellow> for the wireless remote
controller.
(3) Remove the front panel.(see the photo 1)
(4) Remove the electrical parts box.(see the photo 8)
(5) Remove the nozzle assembly.(see the photo 7)
(6) Remove the heat exchanger.(see the photo 12)
(7) Remove the 2screws and electrical heater.
PHOTOS & ILLUSTRATION
(Photo 9)
Set
screw
(Photo 10)
Motor cover
Fan motor
(Photo11)
Heat exchanger
Set screws
Fixture(fixing bearing)
(Photo 12)
Set screw
Pipe fixture
(Photo 13)
35
Motor cover
Fan motor
screws
motor leg
Heat exchanger
Set screws
Set screws
Electrical heater