Advertisement
Warnina
/Avertissement
/Advertencia
/Adverthcia
The marking
of products
using lasers
(Except for some areas)
The label is attached to the chassis/case and
says that the component uses laser beams that
have been classified as Class I. It means that
the unit IS using laser beams that are of a
weaker class. There is no danger of hazardous
radiatron outside the unit.
Marquage
des produits
utilisant
un
laser &auf pour certaines rbgionsl
L'etiquette est attachee au chassislboitter
de
I'appareil et indique que I'appareil utiliser des
rayons laser de classe 1. Cela signifie que
I'apparerl utilise des rayons laser d'une classe
faible. II n'y a pas de danger de radiatron
accidentelle hors de I'appareil.
La marca del product0
/riser
Esta etiqueta esta colocada al chasis/a la caja e
indica que el componente funciona con rayos
laser de classel.
Esto significa que el aparato utiliza rayos laser
consrderados coma de clase debie. No exrste
el peligro de que este aparato emita al exterior
una radiacron peligrosa.
A marca dos produtos
usando laser
(exceto para algumas iireasl
A etiqueta e presa no chassis/estojo
e indica
que 0 componente utiliza raios laser,
classificados coma sendo de Classe 1. lsto
significa que o aparelho esta usando raios laser
que sao de uma classe mais fraca. Nao ha
perigo de radiacao malefrca fora do aparelho.
1 ACAUTION
/
Use of controls or adjustments or performance
of procedures other that? those specified herern
may resirlt In hazardoirs rradratron exposur-e
In complrance with Federal Reguiations,
followrng are reproductrons of labels on, or
inside the product relating to laser product
safety.
f!EFEgy
KENWOOD CORP CERTIFIES THIS EQUIPMENT
CONFORMS TO DHHS REGULATIONS NO.21 CFR
1040. 10, CHAPTER I, SUBCHAPTER J
Location
Rear Panel
FCC WARNING
Thus equrpment may gener-ate or use radio
frequency energy. Changes or modrfrcations to
this equipment may cause harmful rnterference
unless the modrfrcatlons are expressly approved
in the instructron manual. The user could lose
the authority to operate this equipment if an
unauthorized change or rmodrfrcatron IS made
r-my
Thus equrpment has been tested and found to
comply with the limits for a Class E digital
device, pursuant to Part 15 of the FCC Rules.
These limrts are designed to provide reasonable
protection against hat mful interference in a
residentral installatron. This equrpment may
cause harmful rnterferernce to radio
communrcations,
rf rt is not installed and used in
accordance with the rnstructrons.
However,
there is no guarantee that interference will not
occur In a particular rnstallatron. If this
equipment does cause harmful interference to
radio or televrsion reception, which can be
determined by turning the equrpment off and on,
the user is encouraged to try to correct the
interference by one or tmore of the following
measures:
l
Reorient or relocate the receiving antenna.
l
Increase the separatron between the
equipment and receiver.
l
Connect the equipment into an outlet on a
circuit different from that to whrch the recervet
IS connected.
l
Consult the dealer OI an experienced radio/TV
technrcran for help.
(
This Class B digital apparatrrs complies wrth
Canadian ICES-003.
1 REMARQUE
]
Cet appareil numerrque de la classe B est
conforme a la morme NMB-003 du Canada
2
Advertisement
