Harman Kardon MaestroKitchen 100 Installation Manual page 6

9. Use 14 of the supplied door trim panel screws to attach the door trim panel to the inside of
the door. WARNING: Do not put excessive pressure on the electric screwdriver when
attaching the trim panel. If you pre-drilled the pilot holes in Step 8, we recommend
using a manual screwdriver to attach the trim panel.
IMPORTANT: Be sure the exciter wire does not contact the back of the exciter.
10. Attach the hinges to the door and hang the door on the cabinet.
11. Connect the two exciter wire conductors to the two amplifier wire conductors. The connectors will
mate only one way: red wire to red wire, and black wire to black wire. IMPORTANT: Do NOT
cut and splice the speaker wires.
6
Attach panel with small screws.
Keep wire away
from exciter.
Insert connectors all the way
inside vinly insulation boot.
12. Measure the included wire channel and the cabinet wall. If necessary, use a knife to shorten the
wire channel so it will fit along the cabinet wall, leaving 3cm of distance from the channel to
the front of the cabinet.
3cm
13. Use a small screwdriver to open the wire channel, remove the backing from the adhesive strip
from the wire channel base and attach the wire channel base to the cabinet side.
Insert screwdriver and twist to open.
14. Insert the speaker wire in the wire channel base, feeding any excess wire back through the hole in
the rear of the cabinet.
IMPORTANT: Make sure that the metal connectors of the two conductors DO NOT
TOUCH each other inside the channel.
NO metal-to-metal contact.
Run wire inside of channel base.
Installation
Shorten wire channel to fit.
Attach wire channel
base to cabinet side.