Harman Kardon MaestroKitchen 100 Installation Manual page 13

2. Connect the left and right door speaker wires to the head unit's Left and Right Door Speaker connectors:
a. Use a Phillips screwdriver to loosen the screw.
b. Insert the tinned bare wire into the connector under the metal washer. It is very important that the wire be under the washer.
c. Tighten the screw to secure the wire.
d. Connect the wire with the red band to the (+) terminal.
a) Loosen screw.
IMPORTANT: Make sure that the (+) and (–) wires do not touch each other or the
other terminal.
NOTE: You may need to drill a hole for the speaker wires in the kitchen cabinet directly
behind the head unit mounting location.
3. Connect the subwoofer wire to the head unit's Subwoofer 1 connector following the same
method as for the door speaker wires. Connect the wire with the red band to the (+)
terminal.
IMPORTANT: Make sure that the (+) and (–) wires do not touch each other or the
other terminal.
NOTE: If the installation has two subwoofers, connect one to the Subwoofer 1 connector
and the other to the Subwoofer 2 connector. Do NOT connect both subwoofers to a single
speaker terminal.
4. Connect the auxiliary audio cable from the input panel to the head unit's Aux Input connector.
NOTE: You may need to drill a hole for the audio cable in the kitchen cabinet directly behind
the head-unit mounting location.
b) Insert wire under
metal washer.
Aux
Cable
c) Tighten screw to secure wire.
Red band to (+) connector.
5. Connect the USB cables from the input panel to the head unit's USB 1 and USB 2 connectors.
NOTE: You may need to drill a hole for the cables in the kitchen cabinet directly behind the
head-unit mounting location.
USB 1 Cable
6. Place the power supply on the mounting shelf. Connect the power supply to the head unit's
Power Supply connector, connect the AC cord to the power supply and to an AC wall outlet.
Installation
d) Connect the wire with the red
band to the (+) terminal.
USB 2 Cable
Power Supply
13