Canon imagerunner 4570 Printer Manual page 43

I Margin
-1.90 to +1.90 inch (in increments of 0.01 inch); 0.0
This setting sets the page margin in inches. The settings can be set between
-1.90" (-50.0 mm) and +1.90" (+50.0 mm) in increments of 0.01" (0.5 mm).
Use [ ] to increase the width of the inside margin.
Use [ ] to increase the width of the outside margin.
[0 inch]
Center
You can specify the edge along which the margin will be created in the Binding
setting (previous setting). To create a margin along one of the edges of the paper,
use this setting in combination with the Binding setting.
IMPORTANT
If this setting moves the image outside the printable area, part of the image may be
cut off.
NOTE
•
If this setting is used in combination with the Offset X/Offset Y setting, the values of
the two settings are added together.
•
Pressing [ ] increases the setting value by 0.01" (0.5 mm) each time the key is
pressed. Pressing [
down either [
[ + ]
Center
] decreases the value by 0.01" (0.5 mm) each time. Holding
] or [ ] continuously speeds up the value alteration.
* inch
[ - ]
Center
Settings Menu
2
2-13