Printing Problems - Canon imagerunner 4570 Printer Manual

You cannot store a secured print job.
Cause
Remedy

Printing Problems

Meaningless characters are being printed.
4
Cause 1
Remedy
Cause 2
Remedy
A font that is different from the one specified is printed.
Cause
Remedy
You cannot print the last page.
Cause
Remedy
4-8

Printing Problems

The number of secured jobs stored in the machine has exceeded the maximum
capacity of 50 jobs, or the total number of pages that are stored or are in jobs
has exceeded the limit (8,000 pages).
Delete other secured jobs, or wait until those jobs have finished printing, then
print again.
You have printed from Windows without installing the printer driver for Windows
that was included with the machine.
Install the printer driver for Windows that was included with the machine and
print the data again. (See Chapter 2, "Getting Started," in the PCL Driver Guide,
the PS Driver Guide, or the UFR II Driver Guide.)
MS-DOS application software printer settings are incompatible.
Reset the MS-DOS application software printer settings on a printer that is
compatible with the machine. (See the application software manual.)
The 'Send According to Font Substitution Table' setting has been set on the
printer driver for Windows.
Set the 'Send According to Font Substitution Table' setting to the correct setting
and print the data again. (See the Help function on the printer driver.)
The command that identifies the end of the data has not been sent from the PC.
(The Processing/Data Indicator is flashing or lit.)
Clear the print data. (If you print from application software that does not have a
print function and the last page of data is not a full page, the data will remain in
the machine's memory.) (See Chapter 5, "Checking Job and Device Status," in
the Reference Guide.)