Table of Contents
Advertisement
48
EN
On-Screen
Timer
Programming
NUMBER
MENU
When Using The Illumi-Guide Feature
Buttons light or blink on the remote control for
approximately 10 seconds. If the button or buttons extinguish
during timer programming, press ILLUMI GUIDE and the
button or buttons previously lit or blinking come back on. If
the button or buttons do not re-light or start blinking again,
press MENU as many times as necessary to return to the
normal screen and extinguish all illuminated buttons,
and re-perform the timer programming procedure from the
beginning.
If for some reason the remote control's signal is not received
by the VCR, press MENU as many times as necessary to
return to the normal screen and extinguish all
illuminated buttons, and re-perform the timer programming
procedure from the beginning.
1
2
3
4
5
6
7
8
9
0
CH
OK
TIME SCAN
ILLUMI GUIDE
TIMER RECORDING (cont.)
You can directly program the VCR's timer to record up to 8
shows, as far as a year in advance. Remember, the clock must be
set before you can program the timer (
You can also use the optional Illumi-Guide feature, where the
relevant buttons on the remote control light to tell you which
button to press next. The Illumi-Guide feature is activated by the
ILLUMI GUIDE button on the remote control. The Illumi-Guide
feature is only active when the remote control's TV/CABLE/VCR
switch is set to "VCR". (Illumi-Guide is an optional help feature
which makes programming easier. It is not necessary to use
Illumi-Guide to program the VCR.)
LOAD A CASSETTE
1
Make sure the record safety tab is intact. If not, cover
the hole with adhesive tape, then load.
8
The VCR comes on, and the counter is reset,
automatically.
CH
ACCESS ON-SCREEN
MENU
2
To use the Illumi-Guide feature press ILLUMI GUIDE.
The MENU, REW, PLAY and FF buttons will light.
Press MENU as many times as necessary to bring up the
Main Menu screen.
If you are using the Illumi-Guide feature, MENU
lights up and OK blinks.
ACCESS PROGRAM SET
SCREEN
3
Make sure the arrow is to the left of "PROGRAM SET",
then press OK.
If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: NUMBER keys (0
– 9), TIME SCAN, CANCEL and MENU.
SELECT PROGRAM NUMBER
4
Press the appropriate
NUMBER keys or CH5 ∞ or
TIME SCAN 5 ∞ to select a
vacant program number,
then press OK. The first time
you set the timer program-
ming function, all the
program numbers will be
blank; in this case just press
OK when the Program Set screen appears.
If you are using the Illumi-Guide feature, OK blinks
when the following buttons are lit: NUMBER keys
(0 – 9), TIME SCAN, CANCEL and MENU.
pg. 8 or 9).
PROGRAM 1
DATE
- - / - -
START
- - : - - AM
STOP
- - : - - AM
CHANNEL
- - SP
PRESS NUMBER KEY(0-9)
OR ( 5 ,∞), THEN (OK)
PRESS (MENU) TO END
Advertisement
Table of Contents
