Installation; Pin Code; Pin Code Deactivated; Pin Code Activated - Fält Communications AB 252236 User Manual

1. Installation

Find a suitable place where to mount the GSM gateway following these guide lines:

Make sure the GSM coverage is good before the GSM gateway is mounted.
Place the Gateway near a window if possible.

Make sure the LEDs on both sides are visible.

Make sure there is a power source, 230 VAC or 12-24 VDC reachable.

Connect the antenna. Place the antenna as far away from the Gateway as possible.
The antenna can be placed on any magnetic metal surface.

Connect the FältCom ECII™ Flex to the Phone input.
Use the 122033 Modular cable and the terminal connector if required.

1.1 PIN code

Note: The GSM gateway must always be turned off before inserting or removing the SIM card. Please
see section "Turn off the GSM Gateway" before removing a SIM card.
Choose whether the PIN code should be activated or deactivated.

1.1.1 PIN code deactivated

Use a mobile phone or other equipment to deactivate the PIN code on the SIM card.

1.1.2 PIN code activated

The PIN code must be set to "1234". Use a mobile phone or other equipment to set the PIN code to
"1234".
At startup the GSM Gateway will automatically change the PIN code to a random 4-digit code to
prevent misusage of the SIM card. If the SIM card is to be used later; use the PUK code to unlock the
SIM.

1.2 Startup

Start the GSM Gateway:

Gently insert the SIM-card into the GSM unit as shown in the pictures above.
Make sure the cut corner of the SIM is on the left side and the connector pads facing down.

Connect the power cable.
The startup might take up to 30 seconds before the GSM Gateway has established a
connection with the GSM network. For information on how to understand the LED indications,
please see section 2 and section 3 below.

1.3 Turn off the GSM Gateway

1. Remove the DC power connector from the GSM Gateway.
2. Push the RESET button with a short push to turn the unit off.
1.4

Change SIM card

If the SIM-card needs to be changed; the new SIM-card must have "1234" as PIN-codes or have the
PIN-code deactivated.
1. Turn off the GSM Gateway; remove the DC power connector from the GSM Gateway.
2. Push the RESET button with a short push to turn the unit off.
3. Remove the old SIM and insert the new SIM as shown in the pictures above.
4. Connect the power cable.
162236M User Manual GSM Gateway 4