Led Control On Signal Strength; Battery Control; Battery Sms - Fält Communications AB 252236 User Manual

6.2.1 LED control on signal strength

There are two LED's showing the strength of the GSM signal; S1 and S2. You can set the limits when
to light these LED's.

6.2.2 Battery control

The GSM Gateway can be used with or without battery backup. The default setting is battery Mounted
and Battery fault alarm enabled.
The Battery fault alarm can be disabled by unchecking the Battery fault alarm box. This setting will
disable the Battery fault alarm but still charge the battery.
If the lift has a battery backup system the battery in the Gateway can be removed, uncheck the
Mounted battery box to disable all battery charge, test and alarm.

6.2.3 Battery SMS

For information on the battery SMS please see the section 4 Battery.
Fill out the "GSM Battery alarm nr"; where to receive battery alarm SMS.
-
Fill out the "GSM Battery alarm text"; SMS text from the Gateway in case of battery alarm.
-
E.g. Low voltage on battery from lift 4435.
Fill out the "GSM Battery reset text"; SMS text from the Gateway when the battery is replaced.
-
E.g. Low voltage battery reset from lift 4435.
162236M User Manual GSM Gateway 13