Chapter 3.
Installing the Modem
3.1 Hardware Installation
This chapter describes how to install the Modem and establishes network connections. You may install the Modem on
any level surface (ex. a table or shelf). However, please take note of the following minimum site requirements before
you begin. Stick the 4 rubber feet at the bottom(Please refer to appendix E: Attaching Rubber Feet).
3.2 Pre-installation Requirements
Before you start actual hardware installation, make sure you can provide the right operating environment, including
power requirements, sufficient physical space, and proximity to other network devices that are to be connected. Verify
the following installation requirement:
• Power requirements: 5VDC (1A or above)
• The Modem should be located in a cool dry place, with at least 10cm/4in of space at the front and back for well
ventilation.
• Place the Modem away from direct sunlight, heat sources or areas with a high amount of electromagnetic
interference.
• Check if network cables and connectors needed for installation are available.
•
Avoid installing this device with radio amplifying station nearby or transformer station nearby.
NH-300SP 2Ethernet HPNA Modem USER'S MANUAL Ver. A.7
11