Snmp Trap Management - D-Link DGS-3100 SERIES Hardware Installation Manual

DGS-3100 Series Gigabit Stackable Managed Switch Hardware Installation Guide
All parameters are manageable from any SNMP management platform, except the SNMP management station IP address
and community (community name and access rights). The SNMP management access to the switch is disabled if no
community strings exist. The device switch is delivered with no community strings configured.
The following syntax displays the default device configuration:
DGS3100# create snmp community Tony read_write view Default
DGS3100# sh snmp community
Community-Name
-------------------- ------------------ -------------- ------------
Access
Tony
Total Entries 2
DGS3100# create snmp host 100.1.1.3 v1 Tony
DGS3100# show snmp host
SNMP Host Table
Host IP Address
-------------------- ---------------------- ------------------------- ------------
100.1.1.3
Total Entries: 1

SNMP Trap Management

Traps are messages which alert network personnel of events that occur on the switch. The events can be as serious as a
reboot, or less serious like a port status changes. The switch generates traps and sends them to the trap recipient.
This completes the initial configuration of the device from a local terminal. The configured parameters enable further device
configuration from any remote location.
33
View name Access Right
Default
Default
SNMP Version
V1
Community Name / SNMPv3
read write
read write
Tony