Foam Stand Installation - RaceAmerica 3850B Timer AC4 Owner's Manual

7540D - Foam Stand Assembly Instructions
Base Foam
'AA' Battery Emitter (5040B, 5050B & 5058B)
1. Install batteries and turn on the Emitter.
2. Separate the Base of the Foam Stand from the Top.
3. Place the 5040/5050/5058 Emitter into the Base
foam with the battery side down.
4. Slide the Top on the Base paying attention to the four
corner pins and thier lignment with the corresponding
Base holes. Place on the track.
Track Sensor (5140D & 5158D)
1. Separate the Base of the Foam Stand from the Top.
2. Connect the cable to the sensor
3. Place the 5140/5158 Sensor into the base (open end down)
4. Slide the Top on the Base paying attention to the four
corner pins and thier lignment with the corresponding
Base holes. Place on the track.
'C' Battery Emitter (5042B)
1. Same as above except place the 'C' Battery pack in
the Base standing on its edge.
For additional stability
1. Place weight in the Base well as required.
Outside Dimensions:
6.5" W x 7.25" L x 7.5" H
Top Foam
Assembly Components
Emitter
Sensor
Complete Assembly
RaceAmerica Model 3850 Timer AC4
Sensor/Emitter
placement in Foam Base
Sensor back
Note cable routing
7540D 09/30/13
25