Yamaha XV19CSA Owner's Manual page 23

Table of Contents

Advertisement

Right
1. Engine stop switch "
/
"
2. Light switch (for optional lights) "
3. Start switch "
"
Dimmer switch "
/
"
Set this switch to "
" for the high
beam and to "
" for the low beam.
Turn signal switch "
/
To signal a right-hand turn, push this
switch to "
". To signal a left-hand
turn, push this switch to "
leased, the switch returns to the center
position.
Since this model is equipped with a
self-canceling system, the turn signal
lights will self-cancel after the vehicle
has traveled both about 150 m (490 ft)
INSTRUMENT AND CONTROL FUNCTIONS
and for approximately 15 seconds.
However, the turn signal lights can also
be canceled manually by pushing the
switch in after it has returned to the cen-
ter position.
TIP
The self-canceling system only oper-
ates when the vehicle is moving, so that
the turn signal lights will not self-cancel
while you are stopped at an intersec-
tion.
"
Horn switch "
EAU12400
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
EAU12430
the engine. Set this switch to "
"
stop the engine in case of an emergen-
cy, such as when the vehicle overturns
or when the throttle cable is stuck.
". When re-
Light switch (for optional
lights) "
This model can be equipped with op-
tional lights available at a Yamaha
dealer.
EAU12500
"
EAU12660
/
"
" before starting
" to
EAU38331
"
4-6
Push this switch to the left to turn the
optional lights on and to the right to turn
them off.
NOTICE
Do not install a bulb which exceeds
12 V, 35 W in either light, otherwise
the headlight fuse may blow or the
battery may discharge.
Start switch "
"
Push this switch to crank the engine
with the starter. See page 6-1 for start-
ing instructions prior to starting the en-
gine.
The engine trouble warning light will
come on when the key is turned to "ON"
and the start switch is pushed, but this
does not indicate a malfunction.
"SELECT" switch
This switch is used to perform selec-
tions in the odometer and tripmeters, to
set the clock and to set the brightness
control mode of the multi-function
meter unit.
ECA15321
4
EAU12711
EAU41700
EAU44602

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xv19caStar

Table of Contents