Miele KM 6113 Operating And Installation Instructions page 46

Problem solving guide
Problem
After switching the cooktop
on,"L" appears in the front
left and "C" appears in the
front right cooking zone
display.
After switching the cooktop
on, d appears in the front
left and E appears in the
front right cooking zone
display.
The cooking zones won't
heat up.
A cooking zone or the entire
appliance switches off
automatically.
The Booster has
automatically deactivated
early.
The cooking zone is not
working in the usual way at
the power level set.
Power setting 9 is
automatically reduced if the
combined cooking and
casserole zones are set to
power setting 9.
The appliance switches off
during operation and F
appears in all cooking zone
displays.
The food in the pan hardly
heats up or does not heat
up at all when the Auto
heat-up function is
switched on.
The fan continues to run
after the cooktop has been
switched off.
46
Possible cause
The system lock has been
activated.
The appliance is in demonstration
mode.
A cooking zone has been
operated for too long.
The overheating protection
mechanism has been activated.
The overheating protection
mechanism has been activated.
If both zones are operated on
power setting 9, the overall power
outlet might be exceeded.
One or several of the sensors are
covered, for example, by finger
contact, food boiling over or by an
object such as an oven glove or
tea towel.
There is too much food in the pan. Start cooking at the highest
The pan is not conducting heat
properly.
The fan will continue running until
the appliance has cooled down. It
will then switch itself off
automatically.
Remedy
You need to deactivate the
system lock (see "Safety lock").
You need to deactivate the
demonstration mode (see
"Programming").
This doesn't indicate a fault.You
can continue operation (see
"Safety switch-off").
See "Overheating protection".
See "Overheating protection".
Clean the control area or remove
the obstruction (see "Safety
switch-off").
setting, then turn the heat down
manually.