Table of Contents
Advertisement
2-10
LAND CRUISER
(2F
ENGINE)
-
Maintenance
Operations
BRAKES
15.
INSPECT BRAKE LINE PIPES
AND
HOSES
NOTE:
Inspect in
a well lighted area,
Inspect
the entire
circumference
and
length
of the brake hoses using a mirror
as required. Turn the front wheels fully right or
left
before
inspecting
the
front
brake.
(a)
Check all brake lines and hoses for:
•
Damage
•
Corrosion
•
Wear
•
Leaks
•
Deformation
•
Bends
•
Cracks
•
Twists
(b)
Check all clamps for tightness
and
connections for
leakage.
(c)
Check that the hoses and lines are clear of sharp edges,
moving parts and the exhaust system.
(d)
Check that the lines installed
in
grommets pass
through the center of the grommets.
16. INSPECT REAR BRAKE LININGS AND DRUMS
(a)
Check the
linings
for wear.
Minimum lining thickness:
1.5 mm
(O.059
in.)
(b)
Check
the brake drums for scoring or wear.
Maximum drum inside diameter:
297 mm
(11.69
in.)
(c)
Clean
the
brake parts with a damp
cloth.
NOTE:
Do
not use compressed air to clean the brake
parts.
17.
INSPECT FRONT BRAKE PADS AND DISCS
(a)
Check
the
th ickness of the disc brake pads and check
for irregular wear.
Minimum pad thickness:
1.0 mm
(0.039
in.)
(b)
Check the disc for wear or runout.
Minimum disc thickness:
19.0 mm
(0.748
in
.)
Maximum disc runout
:
0.15 mm
(0.0059
in
.)
'--___________
-""=~='"
CHASSIS
lB.
REPACK FRONT WHEEL BEARINGS
(a)
Change the front wheel bearing grease.
•
Remove the hubs and
inner
and
outer
bearings.
Clean in so lvent and inspect the bearings for
damage.
•
Pack the bearings and axle hubs with lithium base
multipurpose grease.
Grease grade:
Lithium base
multipurpose grease
INLGI
No.
21
...
-
-
Hide quick links:
Advertisement
Table of Contents
