Setting Up A Conference; Assigning A Number To A Device - Phonak Condor User Manual

Note: All parameters, including volume settings, are stored and remain the
same when a device is switched off or the battery removed.

Setting Up a Conference

To set-up a conference, the following actions must be performed:
1.
Assign a number to each device taking part in the conference.
2.
Tune devices into the same frequency hopping table.
3.
Enable devices to enter the conference.

1. Assigning a Number to a Device

To set-up a communication session, all the devices that will take part in the
conference must be identified and a number assigned to each.
There can be 2 - 6 devices in any one conference. Each device is given a
unique number – ranging from 01 through to 06.
One device must be assigned number 01 (making this the 'master' device).
Full capacity
75% capacity
Less than 50% capacity – a recharge is
recommended
Less than 25% capacity – a recharge is required
Minimum capacity - the device cannot function.
Keypad Locked / Unlocked
Keypad is unusable except for the On/Off
function.
Condor
8