Stereoscopic microscopes are used for viewing 3-dimensional objects, inspection or assembly of small parts, and for dissection of biological specimen. They provide an upright, unreversed image which permits easy manipulation of the object being viewed while looking through the microscope. They are designed for viewing solid objects at low magnification, but they will also permit viewing of some transparent specimen slides.
Page 4
9. STAGE CLIPS: Two locked-on clips hold specimen slide inplace on stage plate. 10. STAGE PLATES: Frosted stage is generally used for viewing transparent specimen and the black and white stage plate for viewing opaque specimens. 11. STAGE PLATE LOCKING SET SCREW: Locks 80mm stage plate into recesses of microscope base. 12.
Page 5
Incidental illumination can be used with either frosted glass plate or black/white plastic stage plate. Transmitted and incidental illumination combined can provide extra illumination for certain objects where additional top illumination will enhance the object being viewed. NOTE: THE TRANSMITTED LIGHT POSITION REQUIRES USE OF BLUE FILTER AND FROSTED GLASS STAGE PLATE.
MAINTENANCE WARNING: For your own safety, turn switch off and remove plug from power source before maintaining your microscope. If the power cord is worn, cut or damaged in any way, have it replaced immediately to avoid shock or fire hazard. 1.
B. To replace bottom bulb ..gently lay microscope on side. Remove cover plate located on bottom of base by removing four Phillips screws adjacent to corners and one Phillips screw at front of plate. Do not remove Phillips screw at center of plate. Slowly swing plate aside, making sure your don’t yank loose the wire attaching plate to the base.
Manufacturer warrants software to be free from defects in material and workmanship under normal use and service for 90 days from date of purchase. Other than set forth above, National hereby disclaims all warranties, express or implied, of fitness for a particular purpose.