Recording; Editing - JVC HR-P51A Instructions Manual

Recording

Use the following procedure to record TV programmes on a
blank video tape.
Before proceeding:
To record TV programmes, the video cassette player must
be connected to the TV as shown in connection B of the
"Connections" section.
Turn on the power of the TV and video cassette player.
Make sure that the video cassette's safety tab is intact. If it
has been removed, cover the hole with adhesive tape.
1
INTELLIGENT
PICTURE
OPERATE STANDBY
SP/LP/EP
NTSC
NTSC 3.58/4.43 ON PAL TV
INTELLIGENT
NTSC3.58
RECORDING & PLAYBACK PICTURE LP/EP
NTSC4.43 PAL NTSC
1
Load a blank video tape.
Press the Record ¶ ¶ ¶ ¶ ¶ button to start recording. (On the
2
remote control unit press the Record ¶ ¶ ¶ ¶ ¶ and Play 3 3 3 3 3
button at the same time.)
The recording indicator will light during recording.
7 Press the Stop/Eject § button or the remote control's
Stop & button to stop recording.
To stop recording temporarily:
7 Press the Pause 8 button.
The recording indicator will blink.
Press the Play 3 button to resume recording.
Notes:
To engage recording standby, press the Record ¶ button
and then press the Pause 8 button. The recording indicator
will blink during recording standby. Press the Play 3 button
again to start recording.
If the Record button does not work, check to see if the
cassette safety tab has been removed.
The player automatically stops when record-standby contin-
ues for more than 5 minutes.
The video tape will be rewound automatically when the end
of the tape is reached.
TV
2
- TVCH + OPERATE
- VOLUME + TV/VIDEO
VIDEO
TV/VIDEO OPERATE
AUTO - TRACKING +
2
( + - + (
[ L J
REMOTE CONTROL UNIT

Editing

Editing To/From Another Recorder
Player
40
32
RF OUT
K
G
ANT.
IN
1-
Audio/Video signals
40
32
RF OUT
K
G
ANT.
IN
1-
Recorder
TV
Receiver
1 Connect the player's AUDIO and VIDEO OUT connectors
to the recorder's AUDIO and VIDEO IN connectors.
2 Put the player in the Play mode.
Put the recorder in the Record mode.
3
Notes:
NTSC tapes being played back in the NTSC PLAYBACK ON
PAL TV mode cannot be dubbed to another recorder.
When you dub an NTSC tape using your recorder as the
playback deck, select NTSC 3.58 (or 4.43) with the Colour
System Output switch.
Important:
7 To edit, both the player and the recorder must be of the
same colour system. Press your recorder's Colour sys-
tem switch to select the appropriate colour system.
10-
IN OUT
AUDIO
VIDEO
10-
IN OUT
AUDIO
VIDEO
VIDEO CHANNEL
9