Status > Bridge; Status > Wireless; Status > About - Cisco Linksys WET610N Quick Installation Manual

Chapter 3
Upgrade Firmware
Please select a file to upgrade the firmware
Browse and select the firmware upgrade file. Then click
Start to Upgrade and follow the on-screen instructions.
Status > Bridge
The Bridge's current status information is displayed.
Status > Bridge
Bridge Information
Firmware Version The Bridge's current firmware is
displayed.
Local Network
Local MAC Address The Bridge's MAC Address, as seen
on your local, Ethernet network, is displayed.
IP Address The Bridge's IP Address, as seen on your local,
Ethernet network, is displayed.
Subnet Mask The Subnet Mask configured for your local
network is displayed.
Status > Wireless
Information about your wireless network is displayed.
Status > Wireless
Wireless-N Ethernet Bridge with Dual-Band
Wireless
Click Link Status
network is displayed.
MAC Address
local, wireless network, is displayed.
Network Name (SSID)
SSID is displayed.
BSSID The wireless MAC address of the connected
wireless router (or access point) is displayed.
Radio Band
displayed.
Channel Width
wireless network is displayed.
Wide Channel
your network router, the Wide Channel is displayed. If you
selected Wide - 40MHz Channel for the router's Radio Band
or Channel Width setting, then this will be your primary
Wireless-N channel.
Standard Channel
displayed. If you selected Wide – 40MHz Channel for
the router's Radio Band or Channel Width setting, then
the Standard Channel will be a secondary channel for
Wireless-N.
Bit Rate The data transmission rate is displayed.
Signal The percentage of signal strength is displayed.
100% is the strongest signal strength possible; 0% is the
weakest possible.
Security The security method of your wireless network
is displayed.
Status > About
Information about the web-based utility is displayed.
Web Server
Powered By
displayed.
Advanced Configuration
The status of the connection to your wireless
The Bridge's MAC Address, as seen on your
The wireless network name or
The radio band of your wireless network is
The channel width, in MHz, used by your
Depending on the channel settings of
The Standard Channel setting is
Status > About
The web server of the web-based utility is
11