Panasonic Toughbook CF-50 Series Manual page 64

Dealing with Problems
Disk Operations (continued)
Cannot eject disc
A blue background ap-
pears on the screen with
the MPEG image
The CD drive vibrates a
lot
The disc tray does not
close
Others
No response
Is the computer powered on?
To remove a disc when the computer is powered off, insert a pointed object (e.g., the
bent-out tip of a paper clip, or the tip of a pencil or ballpoint pen) into the emergency
hole. Pushing it completely to the end will free the tray so that it can be pulled out.
Did you open the CD drive or remove the MPEG disc while it was operating?
Re-insert the MPEG disc and close the CD drive. Press Enter .
Is the disc bent or labeled?
Set [CD Drive Speed] to [Low] in the Setup Utility. (
Did you touch the eject button when you close the tray?
Press Ctrl + Shift + Esc to open Task Manager and close the software
application which is not responding.
After shutting down by pressing the power switch for more than four seconds,
press the power switch to power on and open the application again.
If the program no longer works normally, delete the program using the following
procedure. Then reinstall the program.
Windows 2000 : [Start] - [Settings] - [Control Panel] - [Add/Remove Programs]
Windows XP : [start] - [Control Panel] - [Add or Remove Programs]
(Advanced)
Emergency Hole
(The position of the emergency hole differs depending
on the drive.)
page 50)
64