Panasonic Toughbook CF-50 Series Manual page 60

Dealing with Problems
Display (continued)
The external display no
longer displays properly
When you want to dis-
play the fonts or icons at
a larger size
Windows XP
An error occurs or the
computer freezes while
using Dualview
Battery Indicator
The red indicator lights
The red indicator blinks
The orange indicator
blinks
Shutting Down
Windows cannot be shut
down or restarted
Standby/Hibernation Function
Unable to enter standby
or hibernation mode
Unable to automatically
enter standby or hiberna-
tion mode
The computer does not
resume
Changing the number of colors of the display may affect the screen. Restart the computer.
Windows XP
When using Dualview, use the same display colors for the external display as
those used by the LCD.
Change the settings as follows (for more details, refer to the Windows Help).
Windows 2000
1 Select [Start] - [Settings] - [Control Panel] - [Display] - [Appearance].
2 Select the scheme labeled "large" or "extra large" in [Scheme] to change the font
size, and select [Icon] in [Item] to change the icon size.
3 Select [OK].
Windows XP
1
Select [start] - [Control Panel] - [Appearance and Themes] - [Display] - [Appearance].
2 Select the font size in [Font size], and select [Effects] and then add the check mark
for [Use large icons] to increase the icon size.
3 Select [OK], then select [OK].
You can change the size of the icons, etc. using "Icon Enlarger" (
Operation").
If you use a 3D screen saver while in Dualview mode at a high resolution, an error
may occur or the computer may freeze. Under these conditions, do not use a 3D
screen saver.
The battery level is very low (the charge is less than approx. 9% capacity).
Connect the AC adaptor. You can use the computer when the battery indicator light
is orange. If you do not have an AC adaptor, save your data and power off your
computer. After replacing the battery pack with a fully charged one, turn your
computer on.
Quickly save your data and power off your computer. Remove the battery pack and
disconnect the AC adaptor, then connect them again.
If the problem persists, contact Panasonic Technical Support. The battery pack or
recharging function may be defective.
Battery cannot be recharged temporarily because the internal temperature of the
battery pack is outside of the acceptable temperature range for recharging. Once the
allowable range requirement is satisfied, charging begins automatically. Your com-
puter can be used normally in this state.
If a USB device is connected, try removing it.
If a USB device is connected to the computer (note: only for some USB devices),
remove the USB device temporarily. If the problem persists, restart the computer.
If an IEEE1394 device or other peripheral is connected to the computer, disconnect
the device.
Did you press the power switch and hold it for four seconds or more?
If you press the power switch and hold it for four seconds or more, the power will be
turned off forcibly. In this case, all unsaved data will be lost.
(Advanced)
60
"First-time