Panasonic Toughbook CF-50 Series Manual page 15

Security Measures
Setting the User Password
NOTE
When the Supervisor Password has not been set, the User Password can not be
set. Set the Supervisor Password if you have not done so. (
1
Run the Setup Utility
2
Using either
3
Using either
Enter
4
<Only when the User Password has been set>
Enter your password at [Enter Current Password] and press
Enter
5
Enter your password at [Enter New Password] and press
Enter
<When the Setup Utility is started up with the Supervisor Pass-
word>
To disable the User Password
Press only Enter
6
Re-enter your password at [Confirm New Password] and press
Enter
<When the Setup Utility is started up with the Supervisor Pass-
word>
To disable the User Password
Press only Enter
7
At [Setup Notice], press Enter
8
Press F10 and select [Yes], then press Enter
NOTE
Your password will not be displayed on the screen.
Only up to seven alphanumeric characters can be used.
• There is no distinction between upper and lower case letters.
• Use only the upper horizontal row of numeric keys to input your password.
• Do not input your password while holding down Shift or Ctrl .
When you do not want the User Password enabled or changed without
permission:
1 Run the Setup Utility and enter the Supervisor Password.
2 Using and
press Enter .
3 Using and
CAUTION
Do not forget your password. If a password is forgotten, you will be unable to
use your computer. If this happens, log on with the Supervisor Password, or
ask a person who knows the Supervisor Password.
When running the Setup Utility, do not leave your computer even for a short time,
as the possibility exists for the password to be set/changed by another person.
(enabling, changing, disabling)
( page 49)
or , select [Security]
or , select [Set User Password] and press
, select [User Password Protection] in [Security] menu and
, select [Protected] and press Enter .
15
page 14)