Table of Contents
Advertisement
Part names and functions
Install remote control batteries
① Open the battery
compartment lid.
To ensure safe operation, please observe the following precautions:
● Use two (2) AAA or LR03 type alkaline batteries.
● Always replace batteries in sets.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid matter.
● Do not expose the remote control to moisture or heat.
● Do not drop the remote control.
● If the battery has leaked on the remote control, carefully wipe the case clean and
install new batteries.
● Risk of explosion if a battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions on the battery or local
regulations or guides.
Operating range
Point the remote control toward the projector
remote receiver when pressing any button.
The maximum operating range for the remote
control is about 5 meters and 60 degrees.
Adjustable feet
The projection angle can be adjusted up to
10.0 degrees with the adjustable feet.
Lift the front of the projector and press the lock
on the adjustable feet to release it.
The feet are then locked. Rotate the feet to
adjust the height and tilt angle.
Keystone distortion of projected images can be
corrected by remote control or menu operation.
12
②Install new batteries
into the compartment.
③
Two AAA batteries
For correct polarity
(+ and –), be sure
battery terminals
are in contact
with pins in the
compartment.
30°
30°
5m
Adjustable feet
Replace the
compartment lid.
5m
30°
30°
Advertisement
Table of Contents
