Table of Contents
Advertisement
picture 5-35A.
5.2.6.3 PTZ Setup
Picture 5-36
5.2.6.4 Mobile
Picture 5-37
5.2.6.5 Motion Detect
Picture 5-38
Picture 5-35A
Enter into [Main menu Device
channel you want to control and set PTZ protocol (Pelco-D or
Pelco-P), Baud Rate (1200, 2400, 4800, 9600), Stop bit (1, 2),
Parity Check (None, Odd, Even Mark Space), Address Code and
Cruise status respectively. Please note the above mentioned
channel settings must match the settings of the PTZ camera.
Click [Main menu Device Mobile] to enter into [Mobile]
menu.
User Name: indicate user name of DVR.
User password: indicate user password of DVR
Server port: Mobile monitoring port. Setting range is between 1024
and 65535. Please note that
Explanation: Please connect DVR to Internet before setting
DVR port number and the server port no is not equal to network
menus.
Click [Main Device Motion] to enter into the [Motion Detection]
menu to setup motion detection recording.
The [Motion detection] Menu has three sections, including
Channel Status, Sensitivity and Motion area.
Channel STATUS: This option allow you enable motion detection
on any channel.
SENSITIVITY: This option allows you to set sensitivity level of
motion detection from 1 to 4 with 4 being the most sensitive.
18
User Manual
PTZ Setup] to select the
Advertisement
Table of Contents
