Table of Contents
Advertisement
5.2.6.1 HDD Management
Picture 5-30
Picture 5-31
Recording time you have left on the Hard Drive.
OVERWRITE: If you select "on" the system will automatically overwrite the oldest recordings once the
hard drive is full; if you select "off", recording will stop once the hard drive is full.
HDD FORMAT: You use this option to format the hard drive, you can not record files to the hard drive
until it has been formatted. Click [Format HDD] button to start formatting. When selecting [Format HDD]
option the system will prompt you – "Format HDD will loss all the data, do you confirm?" ; click "OK", system
will prompt you – "Is formatting..." and "successful format"; and then system will restart automatically.
USB FORMAT: Use this option to format USB devices.
5.2.6.2 Alarm Set
Picture 5-32
an assigned e-mail account configured under "EMAIL SETUP".
Check the box labeled "FULL SCREEN" on the right if you would like the channel that has detected
motion to automatically expand to full screen.
HDD LOSS, HDD SPACE, VIDEO LOSS: Check this box if you would like to trigger the alarm when HDD
is operating irregularly, HDD is full while "HDD Overwrite" is disabled, or video signal from the cameras has
been loss.
ALARM TIME: Option for the duration of alarm after an alarm is triggered. If "Motion Detect" recording is
enabled, this option controls the duration of the recording time after the motion has stopped.
Click [Main Menu Device
Management] menu (shown as Picture 5-30)
When you install a HDD, the system will automatically detect
if HDD is formatted or not; If HDD needs to be formatted, HDD
status will be shown as "Not format", otherwise, the HDD status
will be shown as "Normal" (refer to Picture 5-31)
TOTAL SPACE: Indicates total space available on Hard
Drive.
FREE SPACE: Indicates unused space available on the
Hard Drive.
USEABLE
REC
detail/quality and frame rate, system will show you how
BUZZER: Options are ON or OFF. Set this to OFF to disable
the buzzer, or set this option to ON and then set the ALARM TIME
option for how long the duration of the alarm will be. This option
must be enabled if any of the alarm option below will be enabled.
OUTPUT: Set the duration of the trigger time of the external
alarm.
MD ALARM and I/O ALARM: Check the box on the left to
enable the buzzer to go off when motion is detected or when the
external I/O is triggered. Check the second box to the right labeled
"EMAIL" if you would like your DVR to send an e-mail to
16
HDD] to enter [HDD
TIME:
Based
on
User Manual
current
image
Advertisement
Table of Contents
