Home Page - Inmarsat Hughes 9202 User Manual

Home page


Using the Web UI
22
3004149-0001 Revision B
The Home page shows the current terminal status and allows
you to setup your initial data connection.
On the left side of the page is the Status bar. These items are
updated automatically when the status of any item changes.
1. Connection: This field indicates whether you are
registered with the Network. It also shows the PS and CS
status, beam type, and receive signal quality.
a. Packet Switched (PS) Attach Status: This field
indicates whether you are PS attached with the
Network. Once PS attached, in most cases you will
still need to setup a PDP context in order to send PS
data.
b. Circuit Switched (CS) Attach Status: This indicates
whether you are CS attached with the Network. Once
you are CS Attached and Registered with the network,
you are able to make CS calls.
2. GPS: This field displays the current GPS position status.
If you have received a GPS fix and the Network GPS
policy has been received and it allows the GPS position to
be shown to the user, it will display the Latitude,
Longitude, Fix Quality, and the Last time the GPS position
was updated. Time displayed is UTC time.
3. BGAN terminal: This field indicates the WLAN and
battery status.
The sample page above shows what appears while the UT is in
antenna pointing mode. Once antenna pointing is complete and
you have successfully registered with the satellite network, the
middle of the page updates: in the middle of the page you will
find the following items:
Current Connection field allows you to activate data
connections for your TE. You can activate a Standard connection
or a Streaming connection. For streaming connections use the
drop down box to select the data rate for the stream.
Connect using APN field allows you to control the APN used
for the connection.
Details shows the status of the connection for this TE.
Visible Satellites shows the satellites visible from your current
location and the pointing information.