Coverage Map - Inmarsat Hughes 9202 User Manual

Coverage Map


Using the Hughes 9202
10
3004149-0001 Revision B
If you wish to use the fax port you must connect an RJ-14
connector that breaks out the two RJ-11 ports into Line 1 and
Line 2. You can then connect to port 2 to access the 3.1k
service for fax (see Application Note at end of User Manual).
To dial, prefix the international number with 00 and terminate
with #. For example, to dial a number in the USA, enter:
0018005551234# (00 + Country code + phone number+ #)
RJ-11 and ISDN handsets cannot be used at the same time.
You must configure the 9202 to ISDN or analog telephony
mode.
When switching between ISDN and analog telephony modes,
the 9202 must be rebooted.
The Inmarsat BGAN service is operated with 3 satellites as
shown below. The Hughes 9202 terminal will perform best in
areas where the elevation (or "look") angle is 20 degrees above
horizontal or higher, but the terminal can operate down to 5
degrees of look angle.