Wan - TP-Link TL-R480T+ User Manual

TL-R480T+
b. If the new LAN IP Address you set is not in the same subnet, the IP Address pool of
the DHCP sever will not take effect, until it is re-configured.
c. If the new LAN IP Address you set is not in the same subnet, the Virtual Server and
DMZ Host may change accordingly at the same time, you'd better re-configure it as
well.

5.4.2 WAN

You can configure the WAN port parameters on this page.
First thing first, choose the right WAN port you are using (WAN 1/WAN 2). Glance the
web, choose the corresponding connection option as your situation, If you are not sure
what do you use currently, please contact your ISP to obtain the correct information.
1. If you choose Dynamic IP, the router will automatically get IP parameters from
your ISP. You can see the page as follows (figure 5-4):
This page displays the WAN IP parameters assigned dynamically by your ISP,
including IP address, Subnet Mask, Default Gateway, etc. Click the Renew button to
renew the IP parameters from your ISP. Click the Release button to release the IP
parameters.
MTU Size: The normal MTU (Maximum Transmission Unit) value for most Ethernet
networks is 1500 Bytes. For some ISPs you need to reduce the MTU. But this is
Load Balance Broadband Router User Guide
Figure 5-4 WAN - Dynamic IP
- 15 -