Clarion NP509 User Manual page 56

Name
Speedometer Shows the current speed both graphically and as a
number.
Distance Shows the distance you need to travel on the route
Remaining before reaching your final destination.
Time Shows the time needed to reach the final
Remaining destination of the route based on information
available for the remaining segments of the route.
The calculation cannot take into account traffic jams
and other possible delays.
Arrival Time Shows the estimated arrival time at the final
destination of the route based on information
available for the remaining segments of the route.
The calculation cannot take into account traffic jams
and other possible delays.
GPS Time Shows the current time corrected with time zone
offset. The accurate time comes from the GPS
satellites, and the time zone information comes
from the map or it can be set manually in Regional
settings.
Altitude
Shows the elevation if it is provided by the GPS
receiver.
Speed Limit
Shows the speed limit of the current road if the map
contains it.
If you tap the previous button, this one replaces it.
Most of the fields on this screen have a
it is attached to is shown on the map as a Trip Data. It also shows the position of the data as follows:
Symbol
This value is not shown on the map screen.
This value appears on the map screen in the Trip Data area. This is the value at the
top.
This value appears on the map screen in the Trip Data area. This is the value in the
middle.
56
Description
symbol next to them. This symbol shows whether the field
Description
Function
Tap this field to show it on the
map screen in one of the Trip
Data fields.
Tap this field to show it on the
map screen in one of the Trip
Data fields.
Tap this field to show it on the
map screen in one of the Trip
Data fields.
Tap this field to show it on the
map screen in one of the Trip
Data fields.
Tap this field to show it on the
map screen in one of the Trip
Data fields.
Tap this field to show it on the
map screen in one of the Trip
Data fields.
Tap this field to show it on the
map screen in one of the Trip
Data fields.
Opens a new screen with
three resettable Trip
Computers.
Tap this button to change the
content of the Route Data
fields to show information
about the next via point.
Tap this button and the Route
Data fields show information
about the final destination
again.