Editing; Audio Dubbing [E439Eg Only] - JVC HR-E239EG Instructions Manual

EDITING

Audio Dubbing
[E439EG only]
+
–
CD Player
1
4
7
NUMBER "0"
2
2 3
6
5
8 9
0
PLAY
PAUSE
Audio dubbing replaces the audio sound of a previously
recorded tape with a new soundtrack.
MAKE CONNECTIONS
1
Connect an audio component to the AUDIO IN
connector on the recorder's front panel.
SET INPUT MODE
2
Press NUMBER key "0". "F-AU" appears in place of a
channel number.
LOCATE START POINT
3
Press PLAY to start playback of the tape in your
recorder, and press PAUSE when you find the point
where you want to start dubbing.
ENGAGE AUDIO DUBBING
4
Press AUDIO DUBBING.
START DUBBING
5
Engage the audio component's Play mode, then press
PLAY to start the tape in your recorder. Audio dubbing
begins at this point.
To stop dubbing temporarily, press PAUSE. Press
PLAY to resume dubbing.
END AUDIO DUBBING
6
Press STOP to stop the tape in your recorder, and
engage the audio component's Stop mode.
NOTES:
Audio dubbing stops automatically when the counter reaches
"0:00:00", and the recorder enters the Play mode. Check the
counter reading before dubbing.
Audio dubbing is also possible using the rear panel AV1 IN/
OUT or AV2 IN connector. When using these connectors,
make sure to select the correct input mode in step 2.
Connections made to the recorder's front panel are given
priority over those made to the rear panel connectors.
Audio dubbing cannot be performed on a cassette that has
had its record safety tab removed.
27
EN