Index Search; Next Function Memory; Tape Position Indicator - JVC HR-E239EG Instructions Manual

Scene Finder
This function helps you check contents of unlabeled recorded
tapes at the touch of a single button.
Search Search
FF REW FF
5 seconds 10 minutes 5 seconds
on counter
NOTE:
Scene Finder cannot be used when the recorder is in the Record
mode.
ACTIVATE SCENE FINDER
1
Press SCENE FINDER. The recorder starts forward high-
speed search for 5 seconds and then fast-forwards 10
minutes on the counter. This cycle is repeated until the
end of the tape is reached.
To start Scene Finder in the reverse direction, press
SCENE FINDER and then turn the SHUTTLE ring to
the left (or press the remote's REW button) within 2
seconds. This cycle is repeated until the beginning of
the tape.
During Scene Finder, the following indications appear
on the display panel:
STOP SCENE FINDER
2
Press STOP.
NOTES:
During Scene Finder high-speed search, you can also hear the
tape sound. During fast forward or rewind, you hear the
current TV sound instead.
Scene Finder does not function during Index Search.

Tape Position Indicator

The tape position indicator appears
on screen when, from the Stop
mode, you press FF, REW or
perform an Index Search. The
position of "5" in relation to "0"
(beginning) or "+" (end) shows you
where you are on the tape.
"O.S.D." ( pg. 18) must be set to
"ON", or the indicator will not
appear.
NOTE:
Depending on the type of tape used, there may be times when
the indication is not correct.
Search
REW FF REW
10 minutes 5 seconds
on counter
3
+ + +
0
1:23:45
REMAIN 2:35

Index Search

Your recorder automatically marks
index codes at the beginning of
each recording. This function gives
you quick access to any one of 9
index codes in either direction.
NOTE:
Before starting, make sure the
recorder is in the Stop mode.
ACTIVATE INDEX SEARCH
1
Press PUSH JOG or
"£ 1" is displayed on screen and search begins in
the corresponding direction.
To access index codes 2 through 9, press PUSH JOG
or repeatedly until the correct index number is
displayed.
Ex.: To locate the beginning of B from the current
position, press PUSH JOG
To locate the beginning of D from the current
position, press PUSH JOG
Current position
A B
–2 –1
When the specified index code is located, playback
begins automatically.

Next Function Memory

You can set your recorder's power to go off automatically after
the tape is fully rewound. Before starting, make sure the
recorder is in the Stop mode.
For Automatic Power Off After Tape Rewind . . .
. . . press REW, then press OPERATE within 2 seconds.
NOTE:
If you want the power to be turned off automatically when the
counter reads "0:00:00" (instead of at the beginning of the
tape), press C.MEMORY so that the "M" mark appears before
pressing REW.
Information On Colour
System
You can also record SECAM signals, or play back a MESECAM
tape on this recorder. When a MESECAM tape is played back,
"MES" appears on the display panel. MESECAM is the designa-
tion for tapes with SECAM signals that have been recorded on a
MESECAM-compatible PAL video recorder.
13
EN
£ 2
(™ or £). "™ 1" or
twice.
once.
C D E F
1 2 3
Index number