Manual Tracking; Tape Position Indicator - JVC HR-DD949EE Instructions Manual

12
EN
REVIEW
1
4
REW
PUSH JOG

Tape Position Indicator

The tape position indicator
appears on screen when, from
the Stop mode, you press FF,
REW or perform an Index
Search. The position of "5" in
relation to "0" (beginning) or
"+" (end) shows you where
you are on the tape.
"O.S.D." ( pg. 9) must be
set to "ON", or the indicator
will not appear.
NOTE:
Depending on the type of tape used, there may be times when
the indication is not correct.
5/8
6
STOP
q 1 ¡
2
2 3
5 6
9
7 8
0
4
TV PROG
FF
3
+
0
REMAIN 2:35
Beginning

Manual Tracking

Your video recorder is equipped with automatic tracking
control. During playback, you can override this and adjust the
tracking manually by pressing the TV PROG buttons.
8
OVERRIDE AUTOMATIC
TRACKING
1
Press SP/LP (
tracking.
ADJUST TRACKING
MANUALLY
2
Press TV PROG + or – to adjust tracking.
RETURN TO AUTOMATIC
TRACKING
3
Press SP/LP (
matic tracking.
NOTE:
When a new tape is inserted, the recorder enters the automatic
tracking mode automatically.
3R Picture
3R(= Resolution and Response Recovery technology) maximises
sense of resolution and sharpens image edges to make playback
picture look better focused.
ACTIVATE 3R PICTURE
1
Press 3R PICTURE. The button will light.
+ +
1:23:45
Information On Colour
System
End
You can also record SECAM signals, or play back a MESECAM
tape on this recorder. When a MESECAM tape is played back,
"MESECAM" appears on the screen for about 5 seconds.
MESECAM is the designation for tapes with SECAM signals that
have been recorded on a MESECAM-compatible PAL video
recorder.
PLAYBACK (cont.)
) on the remote to engage manual
) on the remote to re-engage auto-
To turn off 3R Picture, press 3R PICTURE again so
that the light goes off.
Normally it is recommendable to keep 3R Picture ON
(with the button lit).
Depending on the type of tape used, picture quality
may be better with 3R Picture set to off.
If you use this recorder as the player for editing, be
sure to turn off 3R Picture before starting.
The setting will remain effective even though you
turn on/off the recorder.