Lamps - BMW F 800 GS Rider's Manual

Push two mounts 2 far enough
apart that front suspension fits
between them. Adjust support
pin to match front suspension.
Use locating pins 3 to set front
wheel stand to desired height.
Center front wheel stand rela-
tive to front wheel and push it
against front axle.
Align two mounts 2 so that
front suspension rests securely
on them.
Tighten adjusting screws 1.
Apply uniform pressure to push
front wheel stand down and
raise motorcycle.
OE
with center stand
If the motorcycle is raised
too far at the front the
center stand will lift clear of the
ground and the motorcycle could
topple to one side.
When raising the motorcycle,
make sure that the center stand
remains on the ground. Adjust
the height of the front wheel
stand if necessary.
Ensure motorcycle is standing
securely.

Lamps

Replacing low-beam and
high-beam bulb
Make sure ground is level and
firm and park motorcycle.
Switch off ignition.
Remove cover 1 for high-beam
headlight or cover 2 for low-
beam headlight.
8
111
z