Setting Time Codes - JVC BR-DV600AE Instructions Manual

RECORDING
Time code recording
This unit has a built-in time code reader/ generator. It records time codes during recording. It
does not record the user's bit.
Time codes are recorded according to the recording condition as follows:
Time codes are recorded in the REC RUN mode. (REC RUN: time codes run only during
recording.)
Condition
Time code is preset with this unit.
Time code is not preset.
Preset time codes.
button
DISPLAY
STILL
BARS BLANK
MODE
MENU
MENU SEARCH+
button
button
SET
SEARCH–
button
Memo
When the REC button is held
down in the STOP mode, the
value of the built-in time code
generator is displayed.
E-36

Setting time codes

–
• Time codes preset in the built-in time code generator are re-
corded. (First time only)
• When recording ends, the set time codes becomes void and
regeneration occurs.
The framing mode is selected from the NDF/DF item of the TIME
CODE menu. (NTSC only)
• It reads the time codes recorded on the tape and continues
recording time codes from these values. (Regeneration)
• If no time code is recorded, it starts from "00".
* Sometimes, the time codes recorded at the beginning of the
tape may not be read.
SET button
AUDIO
MUTING
OUT SEL.
button
OUT LEV.
Time codes are preset via the TIME CODE menu. It can be
set via either the remote controller or the Main unit.
Press the OPERATE button on the Main unit or the
remote controller to turn on the power and set the
unit to the STOP mode.
* To set it with the main unit, first remove the cassette from the
unit if it is loaded.
Time code recording
Memo
B
DVCAM NTSC PAL REC INH.
CH-1/3
SEL.
CH-2/4
E
Y/C
BR-DV3000
REW button
–
PLAY button
EJECT
EJECT button
MENIU
REC PLAY PAUSE
PAUSE button
SET
REW
STOP FF
FF button
STOP button