Battery - KYMCO SPIKE 125 Manual

(4) BATTERY

The battery fluid level should be kept within the upper
and lower level lines. When the fluid level nears the lower
level line, refill with distilled water to the upper level line.
When cleaning the terminal terminals, remove the screws
attaching the battery cover on the seat and then open
the battery cover.
When battery terminals are corroded, take out the battery
for cleaning.
After cleaning, apply a thin coat of grease or Vaseline to
battery terminals and then install the battery.
CAUTION:
If the motorcycle will not be used for a long time, the
battery will discharge electricity by itself. Remove the
battery and put it in a cool place after it is fully charged to
prevent electricity leakage.
A clogged or kinked breather tube will increase the battery
inside pressure and result in cracks.
The battery fluid will overflow to corrode the motorcycle
if too much distilled water is filled
Turn off the ignition switch before removal or installation.
The negative (-) terminal shall be removed first and the
positive (+) terminal shall be installed first.
Tighten the loose terminal nuts securely.
Battery Charger
－ －
31