Table of Contents
Advertisement
RECORDING
Settings for analog signal input
Selecting analog input signal
Set the INPUT SELECT switch located on the
front panel to LINE or Y/C.
LINE
: Inputs composite video from the
LINE IN terminal, and analog audio
signals from the AUDIO IN terminal.
Y/C
: Inputs Y/C separate signals from
the Y/C IN terminal, and analog
audio signals from the AUDIO IN
terminal.
Setting Menu screens
Setting VIDEO Menu screen
SET UP [60]: DV (only for U model)
Set here according to the existence of the
setup of analog video signals (composite and
Y/C separate). If it exists, set here to ON. If it
does not, OFF.
Setting AUDIO Menu screen
AUDIO MODE: DV (In DV mode only)
Selects the audio sampling frequency for
recording.
32k
: Records in 12-bit 32 kHz mode. DV
format has up to four channels of
recording tracks available, but this
unit only records onto two chan-
nels: CH1 and CH2.
48k
: Records in 16-bit 48 kHz mode.
Records onto CH1 and CH2.
Memo
Audio dubbing is not available on this unit.
INPUT SELECT switch
Setting SYSTEM Menu screen
REC LONG P. TIME
This is for setting the time for BR-HD50 to
enter the tape protection mode if there is a
long recording pause.
INDEX WRITE: SYSTEM [2/2] Menu
This is for selecting whether to record index
signals automatically when recording starts.
(SYSTEM menu details: XPage 67 to 69)
For settings when recording time
codes, refer to pages 60 and 61.
E-41
Advertisement
Table of Contents
