Table of Contents
Advertisement
② Press Y to clear all drive data.
The Array List screen appears, where you can review the RAID arrays that you have set up.
③ Use the arrow keys to select the array that you want to set up, and then press Enter.
The Array Detail screen appears.
The Array Detail screen shows information about the array that you selected, such as Striping Block
used, RAID Mode, Striping Width, Disk Model Name, and disk capacity.
④ If you want to mark this disk as empty and wipe out all its contents then press C.
⑤ At the prompt, press Y to wipe out all the data, otherwise press N.
⑥ Press Enter again to go back to the previous window and then press F10 to exit the RAID setup.
63
Advertisement
Table of Contents
