Table of Contents
Advertisement
Machine Disassembly and Replacement
This chapter contains step-by-step procedures on how to disassemble the graphics dock for maintenance and
troubleshooting.
Disassembly Requirements
To disassemble the graphics dock, you need the following tools:
•
Wrist grounding strap and conductive mat for preventing electrostatic discharge
•
Philips screwdriver
•
Plastic flat screwdriver
•
Plastic tweezers
NOTE: The screws for the different components vary in size. During the disassembly process, group the
screws with the corresponding components to avoid mismatch when putting back the components.
Related Information
The product previews seen in the disassembly procedures may not represent the final product color or
configuration.
IMPORTANT: Cable paths and positioning may not represent the actual model. During the removal and
replacement of components, ensure all available cable channels and clips are used and that the cables are
replaced in the same position.
General Information
Pre-disassembly Instructions
Before proceeding with the disassembly procedure, make sure that you do the following:
1.
Turn off the power to the system and remove all peripherals.
2.
Unplug the AC adapter and all power and signal cables from the system.
3.
Place the system on a flat, stable surface.
Chapter 2
Chapter 2
7
Advertisement
Table of Contents
